Voltage MAF with 1227730

[Swayze]

not sure about the '730 but I looked at my assortment of service manuals and the MAF/MAT hookups on the voltage variety show the wire coming directly off the MAF whereas the Freq. type the wire is shown coming from the MAT side. (Two different ECMs).by the time the signal gets to the ECM isn't it just voltage anyway?

byE
Mike
Swayze
mswayze at truswood.com
kswayze at bellsouth.net

----- Original Message ----- 
From: "Ludis Langens" <ludis at cruzers.com>
To: "gmecm" <gmecm at diy-efi.org>
Sent: Thursday, May 04, 2000 8:39 AM
Subject: Voltage MAF with 1227730


> Is a voltage output MAF ever used with the '730?  If so, what harness
> pin does it connect to?  Likely candidates are B3 and E10.  Less likely
> candidates are F11, F12, and B7.  Even less likely candidates are A3,
> F14, and F15.  (The location where I could look this up is an asbestos
> hazard until June.)
> 
> I also need circuit diagram names for the two types of MAF sensor.  Some
> possibilities are MAFV, VMAF, MAFA, AMAF, MAFF, FMAF, MAFD, and DMAF.
> 
> -- 
> Ludis Langens                               ludis (at) cruzers (dot) com
> Mac, Fiero, & engine controller goodies:  http://www.cruzers.com/~ludis/
> 
> 
> ----------------------------------------------------------------------------
> To unsubscribe from gmecm, send "unsubscribe gmecm" (without the quotes)
> in the body of a message (not the subject) to majordomo at lists.diy-efi.org
> 
> 

----------------------------------------------------------------------------
To unsubscribe from gmecm, send "unsubscribe gmecm" (without the quotes)
in the body of a message (not the subject) to majordomo at lists.diy-efi.org