Miniram Tip in Problem

[Bob]

Have you checked the adjustment of your throttle position sensor?

Bob

-----Original Message-----
From: owner-gmecm at diy-efi.org [mailto:owner-gmecm at diy-efi.org]On Behalf
Of JN
Sent: Thursday, November 02, 2000 1:55 PM
To: gmecm at diy-efi.org
Subject: Miniram Tip in Problem


Hi,
    I have an 89 Corvette with the 7165 ECM (MAF).  The motor is a mildly
built 350 with a Minram intake.  I had a Super Ram and when I switched to a
Miniram, I developed a slight tip in problem.  Sometimes I'll get a backfire
through the intake.  No vacuum leaks (16-17 in hg) , timing is set at 8
degrees BTDC fuel pressure is set at 50 psi vacuum line off.  I'm running
stock 22 pound multecs.  If I run pressure higher than this the injectors
start to shut down and I actually get less fuel.  This was with the old fuel
pump and the new one.  The 7165 I guess has no pump shot table like the 730.
Do I modify the MAF tables to add more fuel at those low airflow levels?
Some others have claimed the same problem and more pump shot fuel was their
solution.  Block learn values at idle look good though.  Its just when you
goose the gas there is a slight stumble.  It the idle is faster say 1000,
then it does not do it.

Thanks!
Jason

----------------------------------------------------------------------------
To unsubscribe from gmecm, send "unsubscribe gmecm" (without the quotes)
in the body of a message (not the subject) to majordomo at lists.diy-efi.org

----------------------------------------------------------------------------
To unsubscribe from gmecm, send "unsubscribe gmecm" (without the quotes)
in the body of a message (not the subject) to majordomo at lists.diy-efi.org