730 ECM Swap

[Bruce Plecan]

Gee, I like this bait and switch stuff.
Ahh, depends what is is....
BS.
Run for office, your getting good at talking in two directions at once.
Just hope you need a part number again, list or no list will be a cold day
be 4 it sees daylight from me.
To the rest of ya'll sorry
Just post and I guess I just go to off list responses
Bruce



> My take on this so far. You would only need to solder the junkyard wires
at
> the back of the 165 header, and not have to remove any pins from the 7730
> connectors. If you go the brand new route, you'll have to solder the
> terminals to all 7730 wires, insert them into the 7730, and then solder
the
> wires to the back of the 165 header. So maybe a junkyard 7730 harness is
the
> way to go after all to save time. My quote from Pioneer Standard says
there
> is a minimum order charge of $25, but if you can get them yourself, I
guess
> that is the way to go. I was volunteering so I could get them all over the
> $25 min order. Sounds like a group buy has become a bunch of individual
buys.
> As for making a profit from the list buy, I was going to show my cost so
no I
> was not intending to make a profit from the list. HOWEVER, I did think of
> selling my version of the harness on Ebay or my site for a modest labor
and
> parts charge, so I guess I'll bow out.  JW
> --------------------------------------------------------------------------
--
> To unsubscribe from gmecm, send "unsubscribe gmecm" (without the quotes)
> in the body of a message (not the subject) to majordomo at lists.diy-efi.org
>
>

----------------------------------------------------------------------------
To unsubscribe from gmecm, send "unsubscribe gmecm" (without the quotes)
in the body of a message (not the subject) to majordomo at lists.diy-efi.org