165 knock sensor sensitivity

[Romans, Mark]

I need a refresher, Previous discussion there was a thread about either

1) Wrapping the knock sensor threads in teflon tape and torquing it to the
absolute minimum.
2) Extending the knock sensor a short distance from the block using some
threaded tube,
3) Wiring a resistor in line to the knock sensor to quiet it down a bit.
(Any of these HAVE to be better than disconnecting it)

Anyone have any quick and dirty desensitivation procs?

False knock is an issue due to forged pistons/ valvetrain noise.

Thanks.
Mark

----------------------------------------------------------------------------
To unsubscribe from gmecm, send "unsubscribe gmecm" (without the quotes)
in the body of a message (not the subject) to majordomo at lists.diy-efi.org