LT-1 Heads

[Chris Bennight]

TPIS makes a mini-ram intake which is essentially their version of the
LT1 intake to fit normal SBC's.  It already comes with a distributor hole
in the back also, and the appropriate coolant passages.  Of course it is
TPS so it will be $$$, but probably cheaper than trying to adapt an
LT1 intake (and easier) in the long run.

  Chris Bennight
----- Original Message ----- 
From: "Shannen Durphey" <shannen at grolen.com>
To: <gmecm at diy-efi.org>
Sent: Tuesday, September 05, 2000 5:12 AM
Subject: Re: LT-1 Heads


| Not without serious work.  They have no coolant passages, so that will
| have to be accounted for.  The bolts are in a different location, and
| the area which must be machined for the distributor hole is very thin,
| so you may end up reinforcing it to hold the dizzy.
| BTDT.
| Shannen
| 
| WEG1192 at aol.com wrote:
| > 
| > Ok, last question about the LT-1. Even though the heads are reverse flow,
| > will the LT-1 port injection manifold fit the "old" style Gen-1 heads with
| > the canted intake center bolts? Are the ports moved around?
| > 
| > Thanks,
| > 
| > John Wilson
| > ----------------------------------------------------------------------------
| > To unsubscribe from gmecm, send "unsubscribe gmecm" (without the quotes)
| > in the body of a message (not the subject) to majordomo at lists.diy-efi.org
| ----------------------------------------------------------------------------
| To unsubscribe from gmecm, send "unsubscribe gmecm" (without the quotes)
| in the body of a message (not the subject) to majordomo at lists.diy-efi.org

----------------------------------------------------------------------------
To unsubscribe from gmecm, send "unsubscribe gmecm" (without the quotes)
in the body of a message (not the subject) to majordomo at lists.diy-efi.org