Promedit help

[rr]

Don't feel bad, I forget this all the time. You need to give promedit two file
names on the command line. The 'read from file', and the 'write to file'.

After that, just hit 'E' for enter, then the value . . . The data is written
to the file without any other input, just hit 'Q' to exit.

BobR.

WEG1192 at aol.com wrote:

> OK, I have a new Pocket Programmer, a new Daters II, and I'm ready to rock n'
> roll. So I sit down and start trying to edit a stock Audi bin and nothing
> doing. I searched the archives for 2 hours on how to change a value in
> promedit. I even searched my E-mail archives since I thought I remember this
> question before, but no luck. I know this has got to be a simple question, so
> can anyone tell me how to change a table value in Promedit? Also, is saving
> the data to a list file the same as saving it as .bin file?
>
> Exasperated in GA.
> ----------------------------------------------------------------------------
> To unsubscribe from gmecm, send "unsubscribe gmecm" (without the quotes)
> in the body of a message (not the subject) to majordomo at lists.diy-efi.org

----------------------------------------------------------------------------
To unsubscribe from gmecm, send "unsubscribe gmecm" (without the quotes)
in the body of a message (not the subject) to majordomo at lists.diy-efi.org