Australian DIY-WB group buy status

[Peter Gargano]

This is a CC from the DIY_EFI list.

Cut-off for this Australian group buy is in about 24 hours.
It's for the DIY-WB PCB, and also for the not-so-common NTK
sensor that is used for this project (also known as a Honda
V-Tec, Bosch, NGK, Echlin, 7 pin, 5 wire, etc. sensor. - don't
ask, check the archives !!!)

If you've made an order for an Australian board or a sensor
through me already, and you didn't get a confirmation request, then
contact me direct  mailto:wideband at techedge.com.au?subject=WB

Price for the PCB, delivered to your Australian address, should
be < AU$20. Price for a sensor should be < AU$240, with local
freight added to this, although AU$10 should get it anywhere
in Australia overnight. Asian destination freight will be extra.

We have just over a dozen local PCB orders that I have individually
asked each person who responded to the initial offer to confirm.
And we have less than 10 sensor orders, so it looks likely that
I'll still get the PCBs thru' Bob Valentine rather than locally
made as the quantities don't "add up" for a good price. I have not
had any better deal than the ~AU$240 for the correct NTK sensor
through The Parts Bin, so, assuming they actually get stock this
week, that's what I'll be ordering.

Reply to any queries you may have to me direct and I'll post
a summary here - GMECM list will be CC'd.

Peter.
----------------------------------------------------------------------------
To unsubscribe from gmecm, send "unsubscribe gmecm" (without the quotes)
in the body of a message (not the subject) to majordomo at lists.diy-efi.org