Remote EPROM

[Jeffery Green]

I have a Kenne Bell Prompaq which uses a ribbon cable, It's about 18" to 24"
I don't remember.
But it's wrapped in foil and then the put a rubber sheath over that. Works
great and radio
interference.



----- Original Message -----
From: "Christian Hack" <christianh at pdd.edmi.com.au>
To: <gmecm at diy-efi.org>
Sent: Tuesday, February 13, 2001 4:24 AM
Subject: Re: Remote EPROM


> Sounds exactly like me, engine ran (only just and like crap)
> after adding 8" of ribbon cable. Simply wrapping it in alfoil
> fixed the problem. Didn't even have to ground it.
>
> > Date: Mon, 12 Feb 2001 07:58:33 -0800
> > From: romans at starstream.net (Romans, Mark)
> > Subject: Re: Remote EPROM
> >
> > I have mine zif socket on the end of a 12" ribbon cable.  The ecm is
> > in the stock location (87 Vet) and the ribbon cable runs over
> > the outside
> > of the ecm down to where the under dash light was.  This allows me to
> > change the chip by leaning under the passenger side dash.
> > This was extremely susceptible to RFI until I wrapped the ribbon cable
> > in aluminum foil that is grounded to the case of the ecm.
> > Mark
>
>
> --------------------------------------------------------------------------
--
> To unsubscribe from gmecm, send "unsubscribe gmecm" (without the quotes)
> in the body of a message (not the subject) to majordomo at lists.diy-efi.org
>
>

----------------------------------------------------------------------------
To unsubscribe from gmecm, send "unsubscribe gmecm" (without the quotes)
in the body of a message (not the subject) to majordomo at lists.diy-efi.org