Need help

[Ludis Langens]

ae2598 at wayne.edu wrote:
> 
> >   Fiero 2.8 ECM, 3.4 injectors, 3.4 engine:  ECM injects too much fuel
> >   Fiero 2.8 ECM, 2.8 injectors, 3.4 engine:  Not enough fuel
>
> Does the 3.1 version of this motor use the same injectors as one of the
> above listed motors?  If not, might it give you approximately the flow
> rate you want?

I believe that the 3.1 uses the same injectors as the 2.8.  Hence, no
solution to the problem.  However, swapping a 3.4 long block into a
Fiero is somewhat common - I think there is a custom chip available.

-- 
Ludis Langens                               ludis (at) cruzers (dot) com
Mac, Fiero, & engine controller goodies:  http://www.cruzers.com/~ludis/
----------------------------------------------------------------------------
To unsubscribe from gmecm, send "unsubscribe gmecm" (without the quotes)
in the body of a message (not the subject) to majordomo at lists.diy-efi.org