dats a lotsa bins!

[Bruce Plecan]

> steve ravet wrote:
> > Also,
> > I think that all of them have been run through Ludis' bin ID program,
> > and so should have correct checksums, sizes, etc.

Some have.   Most all have been in Hexworkshop, and looked at.   This all
started years ago, and alot has happened since then.

Then just in shear numbers, there will be errors,  never mind distractions
like 747s doing touch and goes.
Bruce

>
> I downloaded the whole batch.  Lots of them haven't been run through the
> program.  There are several damaged files.  At least all of them seem to
> have an undamaged duplicate.  Quite a few files have clearly been
> edited, or are aftermarket chips.
>
> I'm currently teaching BitHoist about many new bins, including some new
masks.
>
> --
> Ludis Langens                               ludis (at) cruzers (dot) com
> Mac, Fiero, & engine controller goodies:  http://www.cruzers.com/~ludis/
>
> --------------------------------------------------------------------------
--
> To unsubscribe from gmecm, send "unsubscribe gmecm" (without the quotes)
> in the body of a message (not the subject) to majordomo at lists.diy-efi.org
>

----------------------------------------------------------------------------
To unsubscribe from gmecm, send "unsubscribe gmecm" (without the quotes)
in the body of a message (not the subject) to majordomo at lists.diy-efi.org