Document re-uploaded

[Bruce Plecan]

You going with the allows on Heater?.
Plugged bypass or restricted.
(2) 1/8" holes in thermostat?.
Hopefully at least a 180 stat?.
Anything else?
Ya gonna post post specifics LOL
Bruce


> My 400 will have all the common coolant passage mods done to it, except
the
> external pipe (eww!).
> THX.

> From: Shannen Durphey Shannen at grolen.com
> > This is kewl.  I never even responded to the ARFP thread until today.
> > DZ, if you're looking for manual tranny .bins for the 7727, speak up.
> I've
> > still got a few left.
> > Unless you're running a ton of gear, Vette bins have too much spark
> advance
> > for iron heads.  And 383's (same stroke as the 400) often need slightly
> less
> > timing at lower rpm.  And 400's tend to get warmer than 350 block based
> > engines. Just FYI, in case you haven't experienced this before.
> >
> > Shannen
> >
> >
> > Dave Zug wrote:
> > >
> > > Following grabbing Shannen's ARFP (thanks! I have a manual 400 TPI in
> the
> > > works for '730!) I noticed that a document I had uploaded to FTP was
> blank.
> > > I uploaded it a while ago. its a text file for you programming types
> > > (without assemblers) for doing a multiple-spark table patch on a '727.
I
> > > think it was even linked from the main EFI page under projects.
Anyway,
> I
> > > RE-uploaded it under the name "727tpsck2.txt".  the file name means
"727
> ecm
> > > TPS check" and basically runs thru some extra operations to see if the
> > > driver wants to use the stock (primary) spark table or the optional
> spark
> > > table. I do not think anyone mailed me with questions or interest, or
> even
> > > negative feedmack but I put it back up there anyway... disclaimer
> intact.
> > >
> > > I have made a utility to slip this patch into a chip file, but there
are
> > > many pre-checks for appropriate use I have not incorporated... still
> playing
> > > with it, but if anyone is interested in a commercial licensing of the
> > > feature, just read the document, steal it and don't tell me how rich
it
> made
> > > you.  ;-)
> > >
> > > ----- Original Message -----
> > > From: Jeremy Gonyou <jgonyou at hotmail.com>
> > > To: <gmecm at diy-efi.org>


----------------------------------------------------------------------------
To unsubscribe from gmecm, send "unsubscribe gmecm" (without the quotes)
in the body of a message (not the subject) to majordomo at lists.diy-efi.org