Limp home mode

[Ludis Langens]

Bob Wooten wrote:
>  
> the question in my mind was which RC network controlled the ~RESET line & that is what i guessed was .2.  maybe i am reading in too much here but if this is not kind of how
> this chip works then what are all the RC networks for? (more rhetorical than anything i suppose).  

Pin 2 turns two of the 5V outputs on and off.  The third 5V output is
always on.  Some of the RC nets might control the duration of the RESET.
 Some are probably for current limiting of the outputs.

> I guess i ought to just tie to the ~RESET line & get on with life????????

Yes.


BTW, _what_ did you do to your message?  I couldn't get it to be
automatically quoted.  I had to copy/paste your text above.

-- 
Ludis Langens                               ludis (at) cruzers (dot) com
Mac, Fiero, & engine controller goodies:  http://www.cruzers.com/~ludis/
----------------------------------------------------------------------------
To unsubscribe from gmecm, send "unsubscribe gmecm" (without the quotes)
in the body of a message (not the subject) to majordomo at lists.diy-efi.org