2 bar ECM again/still (HELP)

[ECMnut at aol.com]

In a message dated 3/29/01 11:30:26 PM Eastern Standard Time, 
nacelp at bright.net writes:

> 
>  Different cals move the outputs around.  The syty code uses a WG, none of
>  the 730s do hence the 730 doesn't have an output for doing that.

Don't take this a bible, but when using syty code in the 730, check the
(used to be) EGR line for possible wastegate output.  
Not sure where to go for egr if that is so.
Mike
----------------------------------------------------------------------------
To unsubscribe from gmecm, send "unsubscribe gmecm" (without the quotes)
in the body of a message (not the subject) to majordomo at lists.diy-efi.org