3.4 dohc o2 sensor and spark plugs

[Ross Myers]

> If its a 96 or newer  X ,the upper plenum must be removed, no other way to
> do it.  95 and older, tilt engine forward, remove rubber seal on firewall,
> should be straight shot with a socket. I've even seen guys notch the
> firewall seam (it's covered by rubber seal you remove). I'd never do that,
> nor recommend it but was sure glad someone else did. Also have seen guy
> remove upper "dog bone" and use a floor jack under the engine to tilt
> forward. Good luck. The X-motors will make you earn your money...O2
> sensor,(sensor 1 ) drop the engine cradle 4 inches in the rear. Be very
> careful when you lower the cradle, any more then 6 inches or so you need
to
> separate the rack from the steering column or when your done you will not
> have any steering.. It gets even better after that..
>
>
> JTM

Stories like that convince me even more that Engineers never work on cars!!.

Ross Myers

----------------------------------------------------------------------------
To unsubscribe from gmecm, send "unsubscribe gmecm" (without the quotes)
in the body of a message (not the subject) to majordomo at lists.diy-efi.org