3.4 dohc o2 sensor and spark plugs

[ae2598 at wayne.edu]

On Wed, 2 May 2001, Ross Myers wrote:

> > If its a 96 or newer  X ,the upper plenum must be removed, no other way to
> > do it.  95 and older, tilt engine forward, remove rubber seal on firewall,
> > should be straight shot with a socket. I've even seen guys notch the
> > firewall seam (it's covered by rubber seal you remove). I'd never do that,
> > nor recommend it but was sure glad someone else did. Also have seen guy
> > remove upper "dog bone" and use a floor jack under the engine to tilt
> > forward. Good luck. The X-motors will make you earn your money...O2
> > sensor,(sensor 1 ) drop the engine cradle 4 inches in the rear. Be very
> > careful when you lower the cradle, any more then 6 inches or so you need
> to
> > separate the rack from the steering column or when your done you will not
> > have any steering.. It gets even better after that..
> >
> >
> > JTM
> 
> Stories like that convince me even more that Engineers never work on cars!!.
> 
> Ross Myers
> 
Some of us do, but probably not the ones that work for car companies!


----------------------------------------------------------------------------
To unsubscribe from gmecm, send "unsubscribe gmecm" (without the quotes)
in the body of a message (not the subject) to majordomo at lists.diy-efi.org