'7730 and TBI?!? (CrossFire/2bbl TBI conversion?)

[Bruce Plecan]

Most of the TBI manifolding would probably benefit from the TBI firing
strategy.
I've run a TBI on a 730 and 749, no real gains.
A 747 done right is as good as anything you'll find.
Bruce


From: "Ken Kelly" <ken73 at ken73.homeip.net>
> I've been poking around on Ludis' crossreferences and noticed where the
> '7730 was used for a couple of years with TBI. However, it's listed as a
L4
> TBI, not V6 or V8. (I assume in that case, that it's a single-barrel TBI.)
> Still, it's using the old TBI style injector with the lower impedance.
> Could a '7730 be adapted to a CrossFire or 2bbl TBI setup?
> One of my reasons being better control over the engine; obviously rewiring
> would be a little more complex than a '7747, but not by any large margin.
> The other main reason being that it spits out 8192 baud data (widely
> supported) as opposed to the slower 160 baud.
> Any thoughts, or should I just drop the idea?
> "The Third" Ken (Kelly) ..

----------------------------------------------------------------------------
To unsubscribe from gmecm, send "unsubscribe gmecm" (without the quotes)
in the body of a message (not the subject) to majordomo at lists.diy-efi.org