Idle too high. How do I adjust

[Brent]

> As far as mounting the VSS, Im wondering about a mechanical tach drive or
> using a pulleyed mechanism and running it that way. Since we have only one
> gear, it seems reasonable that using the right pulley size would allow for
a
> reasonable VSS signal.

The VSS has to stop in order for the ECM to enter "idle", so an engine
driven solution doesn't seem feasible.   You probably should connect the the
Nuetral/Drive switch.

> I have attempted to correct the idle issue by disconnecting the IAC, using
> the suggested methods. This does work. However, it introduces a starting
> problem. It has a hard time starting. So, Im thinking a chip mod is the
most
> comfortable method.
>
> I appreciate everyone's efforts on this.
>
> Greg

I believe you are right.  I looked at a few 454 bins and all had a commanded
idle of 750-800rpms.

Regards,
Brent
<massive snip>


----------------------------------------------------------------------------
To unsubscribe from gmecm, send "unsubscribe gmecm" (without the quotes)
in the body of a message (not the subject) to majordomo at lists.diy-efi.org