[Gmecm] Crane Gold self-aligning rockers.

[Roger Danzy]

I have a TPI 350.  The block is pre '79, Lunati hyd roller cam and kit with 
Crane Gold roller rockers with guide plates, spring seat pressure 130, valve 
adjustment 0 plus 1 turn.  Compression ratio is 10.9, heads are Edelbrock 
aluminum, gas is pump 93 octane.  Knock sensor is stock '86 TPI installed 
dry.  I run 32 total spark advance above 2400 rpm, ignition is stock TPI 
87 - 92 with an Accel Super coil.  I only get 8 to 10 knock counts at 
startup and none while driving unless I really lug the engine in the 1200 to 
1600 rpm range in 5th or 6th gear.  I never hear any knocks.


----- Original Message ----- 
From: "Osku Sneits" <ecm at asdf.org>
To: <gmecm at diy-efi.org>
Sent: Thursday, March 24, 2005 5:35 AM
Subject: [Gmecm] Crane Gold self-aligning rockers.


>
>
> There has been a whole lot of talk lately with the ECM's knock system and
> Crane's rockers. I just wondered, if there's anyone else on this list,
> that successfully runs these rockers without increasing the knock count,
> besides me?
>
> ---
>
>
> _______________________________________________
> Gmecm mailing list
> Gmecm at diy-efi.org
> http://lists.diy-efi.org/mailman/listinfo/gmecm