[Gmecm] Converting eprom to eeprom problem

[Mike Poore]

Vcc is my high signal, and CE was my low. I think CE is a problem too, but I
don't see sig ground on the pinout. Is that just another word for the GND
pin? If yes, does GND really supply a low signal, or will it require other
components to complete? What components will I need?

Thanks, Mike
----- Original Message -----
From: "Rick McLeod" <dunvegan at sbcglobal.net>
To: <mp at FlowersByValerie.com>; <gmecm at diy-efi.org>
Sent: Wednesday, October 05, 2005 12:13 PM
Subject: Re: [Gmecm] Converting eprom to eeprom problem


> If you're using CE to as a bank select, I would
> suspect that to be the problem. I would dip switch a
> static voltage, VCC or sig ground, the CE is an active
> signal that would then be causing it to change banks
> during run, which I'm sure will throw a code form my
> experience of trying to switch banks while running on
> other primitive ECMs.
>
> Just a thought
>
> snipped the rest