[Gmecm] Where to start?????

[Mark Mansur]

The best defs (IMO) for $58 are here: http://www.nwstp.com/
...along the left hand nav bar. Paul at nwstp maintains them and is pretty 
responsive.

You might also (eventually) be interested in this:

http://www.code59.org/

-M


----- Original Message ----- 
From: "Phillip Kuhn" <pmkls1 at yahoo.com>
To: <gmecm at diy-efi.org>
Sent: Sunday, August 27, 2006 9:55 PM
Subject: [Gmecm] Where to start?????


Well I have all my hardware for some chip burning but
I am confused as to which bin and definition (mask I
guess) that I should start with. The vehicle is a n/a
nissan 240sx with a ka24e engine which is a port
injected and runs a distributor. I have a 730 ecm and
was planning on using the $58 code in it. I cant seem
to figure which is the "right" definition file and bin
file to download. Im using tunerpro rt and a burn1
burner from moates.net . I still have some odds and
end pieces to get before actually doing the ecm
conversion but I wanted to get comfortable tuning and
programming in the meanwhile so as to save downtime
after the install. I find it funny that I dont flinch
at the thought of the wiring and schematic reading
ahead but Im pretty nervous about the programming end
of it. As always I appreciate the input, I just wish
that I could give back as much advice as I recieve on
here. Thanks,
Phil

__________________________________________________
Do You Yahoo!?
Tired of spam?  Yahoo! Mail has the best spam protection around
http://mail.yahoo.com
_______________________________________________
Gmecm mailing list
Gmecm at diy-efi.org
Subscribe: http://lists.diy-efi.org/mailman/listinfo/gmecm
Main WWW page: http://www.diy-efi.org/gmecm