correction RE: [Gmecm] Using a 1227748 ecm for fuel conrol only

[Steve Ravet]

________________________________

	From: gmecm-bounces at diy-efi.org
[mailto:gmecm-bounces at diy-efi.org] On Behalf Of Steve Ravet
	Sent: Thursday, January 05, 2006 4:26 PM
	To: gmecm at diy-efi.org
	Subject: RE: [Gmecm] Using a 1227748 ecm for fuel conrol only
	
	With no wheel, and no sensor, there's no PRM info to the module,
and therefore no RPM info to the computer.  You can probably use the
tach connector on your tach, if there is one, to get RPM info to the
ECM, although the signal will need to be cleaned up.
	
	--steve

The above should read "tach connector on your distributor".
 
--steve
 
 

-- IMPORTANT NOTICE: The contents of this email and any attachments are confidential and may also be privileged. If you are not the intended recipient, please notify the sender immediately and do not disclose the contents to any other person, use it for any purpose, or store or copy the information in any medium.  Thank you.

-------------- next part --------------
An HTML attachment was scrubbed...
URL: http://lists.diy-efi.org/pipermail/gmecm/attachments/20060105/12000f50/attachment.html