[Gmecm] re dual4cyldis modulefor v8 use

[Gary Evans]

Hm. Interesting. Let us know if you get it working. I am currently  
using a dual '730 ecu setup on my V12. It works great, but having 2  
ecus is an inelegant solution.


On Oct 2, 2006, at 4:02 PM, Peter Jenkins wrote:

> have been trying with 1227808 using 2 6cyl dis coils for v12
> the only option was as previously mentioned ,run two ecu's
> reason is  you double the rpm which you can work around but limits  
> max rpm to half previous ie 3000rpm
> what I had in mind is a type of  x2 flip flop circuit on the est  
> output double out put pulses and send them along alternating  
> outputs but still run the second sensor to time the second dis pack  
> in start up/limp mode
> Have got a set up on a test bench that works in limp mode fine but  
> can't get the x2 flip flop circuit to work as that is not my line  
> of expertise
>> Peter Jenkins
>> 10336 Murray River Rd
> Pine Mountain Vic. 3709
>> Australia.
>
>> PH 0425 705764
>> Email. info at jenkinseng.com
>> web. www.jenkinseng.com                                 DISCLAIMER
>>  * This email and any attachment may contain confidential  
>> information.
>>     If you are not the intended recipient you are not authorised  
>> to copy
>>     or disclose all or any part of it without the prior written  
>> consent
>>     of Jenkins Engineering.
>>  * Opinions expressed in this email and any attachment are those  
>> of the
>>    sender and not necessarily the opinions of Jenkins Engineering.
>>  * Please scan this email and any attachment for viruses. Jenkins
>> Engineering does
>>    not accept responsibility for problems caused by viruses, whether
>> it is Jenkins Engineering's fault or not!!!
>
> _______________________________________________
> Gmecm mailing list
> Gmecm at diy-efi.org
> Subscribe: http://lists.diy-efi.org/mailman/listinfo/gmecm
> Main WWW page: http://www.diy-efi.org/gmecm