GM ECM TBI Questions
bruce plecan
nacelp at bright.net
Tue Dec 2 02:23:26 GMT 1997
Hook a 12v trouble light at the pump, and when first key on, and
initial crank should get a 2sec on pulse. When the light is on
should hear pump run.
No light, check fuse, and wiring Grk grn/wht pin A1 (24 pin smaller
of 2 ECM connectors).
Light but no noise at all, pump dead or not grounded.
Run a fused wire to pump, and try to start engine, as you connect
wire (with key on) pump should run. Oil Pump May be circulating
oil, but at less than 4 PSI, and not tripping fuel pump run points
in O/P sender.
If engine runs, turn off disconnect jumper, and see if it restarts
if yes fine, if no have sender, wiring problem.
As always when working with fuel have extinguisher handy.
HTH Bruce
More information about the Diy_efi
mailing list