injection conversion h*lp

[Chris Serrano]

Hi,

I am nuts, too.  I just bought a efi intake complete for a 5.0 on ebay
with the intention of putting it on an old 302.  It won't be here for
a week.

I will be looking for the EVTM manual to be sure and hook it all up
right.  

chris...


On Sat, 20 May 2000 11:23:51 -0500, you wrote:

>I just found this list and apologize if this question has been asked a
>redundantly answered, but I could not get the archives to work.
>
>I am putting a late model 5.0 (mass air) into an older vehicle. I have
>the ford motorsports wiring harness advertised for this
>purpose. The instructions are woefully in adequate and read as a
>replacement guide for vehicles that already have ford fuel
>injection. I need to know what sensors and relays are 100% emissions
>related and not necessary to make this conversion, and
>what lead wires I need from that harness so I can wire into the vehicles
>existing start/run/power on functions.
>
>I would love to exchange info with anyone who has done such a conversion
>with the Ford 5.0 sequential mass air conversion.
>
>Regards,
>Kelly B
>
>----------------------------------------------------------------------------
>To unsubscribe from diy_efi, send "unsubscribe diy_efi" (without the quotes)
>in the body of a message (not the subject) to majordomo at lists.diy-efi.org

Sometimes I like the weather in Long Beach, CA.
If mail bounces, please retry!
----------------------------------------------------------------------------
To unsubscribe from diy_efi, send "unsubscribe diy_efi" (without the quotes)
in the body of a message (not the subject) to majordomo at lists.diy-efi.org