Changing output of WB O2 setup (Autronic)

[Glenn & Debbie Woodhouse]

For those interested in using a WB for forced induction tuning, thus being
primarily interested in A/F ranges fron stoich to ~11:1, the NTK and FJO
controller boxes' output voltage only ranges about 0.5 volts.  I suspect
that this is true for the DIY-WB as well, those on the list more familiar
with this project please confirm.  Because of this it is important that
whatever device is reading the controller's output (i.e. DVM, digital
display, or datalogger) should have good analog or a/d conversion
resolution.  In the case of a datalogger, 10 or 12 bit resolution is
recommended.

Glenn.

------------------------------

Date: Mon, 6 Aug 2001 21:41:31 -0700
From: Brian L Massey <blocklm at juno.com>
Subject: Re: Changing output of WB O2 setup (Autronic)

On Fri, 3 Aug 2001 17:24:10 +0200 =?iso-8859-1?Q?J=F6rgen_Karlsson?=
<jorgen.m.karlsson at home.se> writes:

> After looking at the response curve of the canadian unit (FJO inc),
> I have found it not to be very suitable.

JK, could you elaborate a little more on this? Do you really mean the
"curve" itself (it's shape or something else?), *or* the fact that it
occupies 1-4V instead of 0-5v? I have teetered on the verge of buying one
of the FJO's, and would appreciate any feedback you have. Also, I recall
at least one other person on the list who was already using an FJO unit.
If I remember, that bloak's feedback was fairly positive. Tnx.

Brian

________________________________________________________________
GET INTERNET ACCESS FROM JUNO!
Juno offers FREE or PREMIUM Internet access for less!
Join Juno today!  For your FREE software, visit:
http://dl.www.juno.com/get/tagj.
- --------------------------------------------------------------------------
--
To unsubscribe from diy_efi, send "unsubscribe diy_efi" (without the quotes)
in the body of a message (not the subject) to majordomo at lists.diy-efi.org

------------------------------

End of DIY_EFI Digest V5 #689
*****************************

To subscribe to DIY_EFI-Digest, send the command:

    subscribe diy_efi-digest

in the body of a message to "Majordomo at lists.diy-efi.org".

A non-digest (direct mail) version of this list is also available; to
subscribe to that instead, replace "diy_efi-digest" in the command
 above with "diy_efi".



----------------------------------------------------------------------------
To unsubscribe from diy_efi, send "unsubscribe diy_efi" (without the quotes)
in the body of a message (not the subject) to majordomo at lists.diy-efi.org