Honda WB Sensor question

John syko at nmia.com
Tue Jul 24 23:24:04 GMT 2001


Hi,

I just ordered the WB sensor from thepartsbin.com and had a couple 
questions regarding it-

First, here's an excerpt from Mark that posetd his info- "Looking at 
the one I have from NAPA, OS-791, it has stamped on the body
approximately 1/4" down from the wiring juncture, the letters "L1H1". Next
row has "NTK   JAPAN" with "OYO2" stamped on one flat of the nut face. There
are 5 wires but there are seven pins in the plug. The cal resistor is across
the two pins with no wiring. With the offset directional guide for plug
orentation on the top, the wiring, top row, left to right is blank hole,
red, white, black. Second row again from the left, orange, yellow, blank
block where the cal resistor is located. Hope yours is right but it sounds
like you are missing the wiring for the cal resistor.

Mark"

1- On the nut face, I have 'OYO1' stamped on there instead of 'OYO2'- 
something to worry about?
2- The wiring looks the same- but do I assume that the resistor is 
'in' the blank block?

thanks,

John
-- 
----------------------------------------------------------------------------
To unsubscribe from diy_efi, send "unsubscribe diy_efi" (without the quotes)
in the body of a message (not the subject) to majordomo at lists.diy-efi.org




More information about the Diy_efi mailing list