Crank trigger signal, runout, refrigerator magnets in the wheel?

[Bob Wooten]

Thanks, I must have confused the two.

BW

-----Original Message-----
From: owner-diy_efi at diy-efi.org [mailto:owner-diy_efi at diy-efi.org]On
Behalf Of Ron Schroeder
Sent: Monday, May 07, 2001 9:02 AM
To: diy_efi at diy-efi.org
Subject: RE: Crank trigger signal, runout, refrigerator magnets in the
wheel?


At 11:19 PM 5/5/01 -0700, you wrote:
>When I was looking into them (hall sensors, that is) I seemed to recall
that
>some of them will not work @ low rpm.<snip>

If it is a true Hall sensor it should work to 0 rpm.  If it is an inductive
sensor it will have a low rpm limit.
----------------------
Ron Schroeder
Brookhaven National Lab
Building 911A
Upton NY 11793

rjs at bnl.gov
631 344-4561
----------------------------------------------------------------------------
To unsubscribe from diy_efi, send "unsubscribe diy_efi" (without the quotes)
in the body of a message (not the subject) to majordomo at lists.diy-efi.org

----------------------------------------------------------------------------
To unsubscribe from diy_efi, send "unsubscribe diy_efi" (without the quotes)
in the body of a message (not the subject) to majordomo at lists.diy-efi.org