[Diy_efi] [Diy_efi]: prop sensing

[bill.shurvinton at nokia.com]

Might not be a digital solution :-)

-----Original Message-----
From: ext Stephen Andersen [mailto:SAndersen at advan-tek.com]
Sent: Monday, April 22, 2002 12:26 AM
To: 'Diy_efi at diy-efi.org'
Subject: RE: [Diy_efi] [Diy_efi]: prop sensing


INteresting concept.  I would suspect it would require=20
very high sample rates, and also would require some=20
type of slip-ring to get the signals from the gauges
out.  The problem with slip-rings is that they can
be very noisy for a low-signal data acq. situation.=20

Good ones could be pricy...

Steve

> -----Original Message-----
> From: diy_efi-admin at diy-efi.org [mailto:diy_efi-admin at diy-efi.org]On
> Behalf Of William Shurvinton
> Sent: Sunday, April 21, 2002 4:48 PM
> To: Diy_efi at diy-efi.org
> Subject: [Diy_efi] [Diy_efi]: prop sensing
>=20
>=20
> There was a thread some months back talking about the all=20
> pervading knock
> sensing issue where someone mentioned torque sensing. Was=20
> talking with a
> good friend yesterday who does a lot of work with some major=20
> UK race teams
> and  he said that he regularly fits strain guages to=20
> propshafts cranks etc
> Got me thinking and I wondered if anyone had any practical=20
> experience of
> this sort of stuff and whether it is DIY doable. Certainly to me seems
> easier than doing a load of DSP on a microphone to try and=20
> measure knock,
> but I suspect I have overlooked some fundamentals somewhere.
>=20
> Bill
>=20
>=20
> _______________________________________________
> Diy_efi mailing list
> Diy_efi at diy-efi.org
> http://www.diy-efi.org/mailman/listinfo/diy_efi
>=20

_______________________________________________
Diy_efi mailing list
Diy_efi at diy-efi.org
http://www.diy-efi.org/mailman/listinfo/diy_efi

_______________________________________________
Diy_efi mailing list
Diy_efi at diy-efi.org
http://www.diy-efi.org/mailman/listinfo/diy_efi