[Diy_efi] diy - wb help needed

[Sam Ling]

hi

i am going through the assembly of my diy-wb board and 
have come across something that has me confused.  can 
someone take a look at the links below paying close 
attention to references to R11, R12, R13, R31, R35, and
R14.

R11-13, R31 and R35 should be the same resistors as 
indicated in the following link.  R14 in that same link
is a different resistor from the above.

http://www.diy-wb.com/parts.htm

now in these 3 links all 6 resistors are indicated to be 
the same.  one is a list of parts and two are pictures
of a blank board (for reference to where the resistors 
go) and an assembled board.  (look near top right)

http://www.aces.edu/~gparmer/efi/temp/wb/partskit-1.jpg
http://www.aces.edu/~gparmer/efi/temp/wb/bd-1.jpg
http://www.aces.edu/~gparmer/efi/temp/wb/bd-3.jpg

who can shed some insight into this?

thanks
sam
http://netwinsite.com/dbabble/

_______________________________________________
Diy_efi mailing list
Diy_efi at diy-efi.org
http://www.diy-efi.org/mailman/listinfo/diy_efi