[Diy_efi] DIY-WB -temp
Perry Harrington
pedward at apsoft.com
Fri Oct 11 18:49:58 GMT 2002
The usable range of the sensor element is 700-950C. If you exceed 1000C,
the Vs cell's electrolytic reaction is lowered. Below 600C you run the
risk of blackening the Ip pump cell.
The DIY-WB site has info on the heater impedance at several temperatures.
I know the schematic has that information.
--Perry
On Thu, Oct 10, 2002 at 06:54:28PM +0200, Jonathan Norman wrote:
> Hello!
> Does anybody know how high temperature the NTK-sensor can handle and how
> high the resistance in the heater will be at that temperature ?
>
> /Jonathan
>
>
> _______________________________________________
> Diy_efi mailing list
> Diy_efi at diy-efi.org
> http://www.diy-efi.org/mailman/listinfo/diy_efi
--
Perry Harrington Data Acquisition & Instrumentation, Inc
perry at dainst dot com http://www.dainst.com/
Those who would give up essential liberty to purchase a little temporary safety
deserve neither liberty or safety. Nor, are they likely to end up with either.
-- Benjamin Franklin
_______________________________________________
Diy_efi mailing list
Diy_efi at diy-efi.org
http://www.diy-efi.org/mailman/listinfo/diy_efi
More information about the Diy_efi
mailing list