[Diy_efi] efi setup (GPz1100)

[Adam Wade]

--- Bevan Weiss <kaizen__ at hotmail.com> wrote:

> I'm not sure what you mean by factory gauge??
> and the throttle sensor position checker??

There was originally a factory go/no-go tool for
setting up the TPS closed-throttle adjustment.  Start
the bike, set idle to 1100 rpm, and check the tool. 
Adjust sensor, then idle, then check again, until you
get a "go" signal from the tool.

I have the supplemental manual for the GPz1100 here,
but not the base manual for the KZ1000/1100 (which has
the details on the calibration procedure and
reistance/voltage ranges).  Sorry I can't be of more help.

=====
| Adam Wade                       1990 Kwak Zephyr 550 (Daphne) |
|   http://y42.photos.yahoo.com/bc/espresso_doppio/lst?.dir=/   |
| "It was like an emergency ward after a great catastrophe; it  |
|   didn't matter what race or class the victims belonged to.   |
|  They were all given the same miracle drug, which was coffee. |
|   The catastrophe in this case, of course, was that the sun   |
|     had come up again."                    -Kurt Vonnegut     |

__________________________________________________
Do you Yahoo!?
Yahoo! Web Hosting - establish your business online
http://webhosting.yahoo.com

_______________________________________________
Diy_efi mailing list
Diy_efi at diy-efi.org
http://www.diy-efi.org/mailman/listinfo/diy_efi