MEFI installation pictures

[Mathieu Blais]

And how did you setup the fuel vapor lane after?  Is that intake all
aluminium?  I'm really thinking about testing a FI system on my 350 pontiac
engine next summer, but the problem I got is that there's no FI intakes that
will bolt right in, so I'll need to either make some adapter between the TB
and intake (if TBI) or get some bungs intstalled (if I got SEFI).

    Math B
    fireb76 at videotron.ca

----- Original Message -----
From: <Tedscj at aol.com>
To: <gmecm at diy-efi.org>
Sent: Saturday, November 18, 2000 10:59 AM
Subject: Re: MEFI installation pictures


> In a message dated 11/18/00 5:02:09 AM Eastern Standard Time,
> shannen at grolen.com writes:
>
> > That's the high pressure pump and fuel reservoir.
> >  The system is self contained.  All it needs is a low pressure supply
> >  of fuel to the reservoir.  I'm using the original mechanical pump for
> >  that job.
> >  Shannen
>
>
> I'm doing the exact same thing.  The FI pump is in the engine compartment
and
> is supplied by the mechanical.  Wasn't sure if it would work or if it was
a
> good idea, but thought I'd give it a try.  I haven't done enough testing
to
> know how it will work out, but no problems so far.  I'm also using the
vapor
> return line as the fuel return line.
> If any of this sounds like a bad idea, then please let me know before I
'find
> out the hard way'!!!
> --------------------------------------------------------------------------
--
> To unsubscribe from gmecm, send "unsubscribe gmecm" (without the quotes)
> in the body of a message (not the subject) to majordomo at lists.diy-efi.org
>
>

----------------------------------------------------------------------------
To unsubscribe from gmecm, send "unsubscribe gmecm" (without the quotes)
in the body of a message (not the subject) to majordomo at lists.diy-efi.org