[Diy_efi] Moving the CalR on the PCB
renaud
leguillr at COURRIER.UMontreal.CA
Fri Jun 28 13:18:43 GMT 2002
Hi again,
Thanks for the answers on the color of the wires.
I cannot open the Sumitomo plug on the sensor side, to get the resistor and
solder it in my PCB box. I measured with my digital ohmeter R=7.45 ohms.
Can I just get a resistor with the same value and solder it to CalR wires
in my box, or the precision of the ohmeter is not good enough and I should
try again to remove the R in the connector?
If so, is there a trick to avoid breaking the connector while opening it?
Thanks again.
Renaud.
_______________________________________________
Diy_efi mailing list
Diy_efi at diy-efi.org
http://www.diy-efi.org/mailman/listinfo/diy_efi
More information about the Diy_efi
mailing list